1.耗尽;用光
2.过有效期;失效
3.期满;时间到了
4.精疲力竭
5.【板】出局
6.〈旧〉驱逐
1.耗尽;用光
2.过有效期;失效
3.期满;时间到了
4.精疲力竭
5.【板】出局
6.〈旧〉驱逐
1.to use all of something and not have any left
2.if an official agreement or document runs out, it stops being legal at a certain date
3.if time is running out, you do not have long to do something
4.to exhaust (oneself) in running
5.[Cricket]to dismiss a player who is trying to complete a run by breaking the wicket with the ball at the end he or she is running to
6.<dated>to make a criminal or a person who you do not like leave a town
1.to use all of something and not have any left
2.if an official agreement or document runs out, it stops being legal at a certain date
3.if time is running out, you do not have long to do something
4.to exhaust (oneself) in running
5.[Cricket]to dismiss a player who is trying to complete a run by breaking the wicket with the ball at the end he or she is running to
6.<dated>to make a criminal or a person who you do not like leave a town
1."Not grabbing the quickdraw in the middle of that scary runout" is achievable, whereas "sending the route this try" is not.
“在中途又没力又恐怖的时候也不要拉快扣”是可达到的目标，但是“这次就要完攀这条路线”就不尽然了。
2.In this issue, the main aim is to introduce the design of a wheel hub runout measuring instrument with Ethernet interface.
在本课题中，主要介绍了带以太网接口的轮毂跳动量测量仪的设计。
3.A tire manufacturing method includes a method for optimizing the uniformity of a tire by reducing the green tire radial runout.
轮胎制造方法包括优化减少了绿色轮胎径向跳动的轮胎均匀性的方法。
4.The struggling Ferraris are just seventh and ninth on the grid, while neither Renault graduated into the top-ten runout.
挣扎法拉利只是第七和第九位发车，而雷诺既不毕业进入前十名跳动。
5.The result indicates that the load for delamination initiation is increased with the increase of the runout length.
结果表明，增加筋条斜削区长度可以延缓脱层的起始。
6.a snowy runout at the bottom of the ski slope.
滑雪下坡底部的雪的弯曲面
7.In service, fatigue cracking initiated at the plating runout led to lug fracture.
在实际使用中，在镀层的过渡段发生的疲劳裂纹会导致接耳断裂。
8.The maximum runout between the thread and the locating face is 0, 005 mm for nuts up to and including size 26.
螺纹同定位面之间的最大跳动为0,005mm为螺母尺寸代号于等于26。
9.The criteria of determine the quality of CRs is as below: Ratial runout; Flexibility; Axial movement.
判断托辊好坏的标准有以下几条：托辊径向跳动量；托辊灵活度；轴向窜动量。
10.By adjusting the tooling angles, green tire radial runout can be optimized.
通过调整刀具角度，绿色轮胎径向跳动可以优化。